Need help?Do you have a question about the SlimLine Eco 17L and is the answer not in the manual?
Provides essential safety guidelines for operating the water softener.
Minimum and maximum water pressure limits for optimal performance.
Acceptable ambient and water temperature ranges for the unit.
Voltage, frequency, and connection type necessary for the softener.
Instructions for correctly connecting drain hoses, including air gap requirements.
Procedures for attaching water supply and output lines to the softener.
Steps to install the optional factory-provided bypass system.
Guidance on installing a separate 3-valve bypass system.
Instructions for safely connecting the unit to the power supply.
Steps to fill the system and remove air and debris.
Adding water conditioner salt to the brine tank.
Initial setup and configuration of the control unit.
Fine-tuning the output water hardness level.
How to manually trigger the system's regeneration cycle.
Explains the display indicators during regeneration cycles.
Procedure to check the functionality of the water usage meter.
Steps to manually initiate a regeneration cycle.
Identifies error messages for timer malfunctions or required service.
Details shown on the control panel during normal operation.
Steps to enter and navigate installer programming menus.
Adjusting settings like hardness units, capacity, and cycle times.
Procedure to enter the system's diagnostic information mode.
Lists and explains various system status data points.
Steps to safely exit the diagnostic mode and return to service.
Regular checks to ensure the water softener is functioning correctly.
Instructions on how to isolate the unit from the water supply.
Operational details for factory and 3-valve bypass setups.
Guidance on maintaining salt levels and brine cabinet care.
Procedures for cleaning the resin bed and sanitizing the unit.
Diagram illustrating the water flow during the service operational state.
Diagram showing the water flow during the refill stage of regeneration.
Diagram illustrating the process of preparing the brine solution.
Diagram for the brine draw and slow rinse stages.
Diagram illustrating the water flow for ECO* models in service.
Diagram showing water flow during refill for ECO* models.
Diagram for ECO* brine solution preparation.
Diagram illustrating the backwash stage for ECO* models.
Diagram for the brine draw stage in ECO* models.
Diagram for the slow rinse stage in ECO* models.
Diagram illustrating the fast rinse stage for ECO* models.
General| Brand | SlimLine |
|---|---|
| Model | Eco 17L |
| Category | Water Dispenser |
| Language | English |
To Next Page