EasyManua.ls Logo

SmallRig 4329 - FCC Statement

SmallRig 4329
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FCC Statement
ISED Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to pa 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful inteerence in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
inteerence to radio communications. However, there is no guarantee that
inteerence will not occur in a paicular installation. If this equipment does cause
harmful inteerence to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to t to correct the
inteerence by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modications not expressly
approved by the pay.
Responsible for compliance could void the user’s authority to operate this
equipment. (Example- use only shielded inteace cables when connecting to
computer or peripheral devices).
This equipment complies with Pa 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful inteerence, and
(2) This device must accept any inteerence received, including inteerence that
may cause undesired operation.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in poable exposure condition without restriction.
English: This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s).Operation is subject to the following two conditions:
(1)This device may not cause inteerence.
(2)This device must accept any inteerence, including inteerence that may cause
undesired operation of the device.

Related product manuals