How to fix Smart MED Medical Equipment when it doesn't turn on?
If your Smart MED Medical Equipment isn't turning on, first ensure it's properly plugged into a working outlet. Check that the AC power cord is correctly connected to both the power supply and the device. If it still doesn't power on, contact your home care provider to check the device and power supply.
Why is air leaking from my Smart MED iBreeze Medical Equipment mask?
If air is leaking from around your Smart MED Medical Equipment mask, ensure that your mask is fitted correctly. Refer to your mask user guide for fitting instructions or use the Mask Fit function to check your mask fit and seal.
What to do if my mouth is very dry using Smart MED iBreeze Medical Equipment?
If your mouth feels dry while using Smart MED Medical Equipment, it may be due to air escaping through your mouth. Try increasing the Humidity Level. You might also need a chin strap to keep your mouth closed or consider using a full face mask.
How to stop a dry nose with Smart MED Medical Equipment?
If you're experiencing a dry or blocked nose with your Smart MED Medical Equipment, the humidity level may be too low. Adjust the Humidity Level to a more comfortable setting.
Why is there water in my Smart MED iBreeze Medical Equipment mask?
If you notice water droplets in your mask or tubing while using Smart MED Medical Equipment, the humidity level might be too high. Adjust the Humidity Level to reduce condensation.
Why is the air pressure too high in my Smart MED iBreeze Medical Equipment mask?
If the air pressure feels too high with your Smart MED Medical Equipment, the Ramp feature may be turned off. Try using the Ramp Time option to gradually increase the air pressure.
Why is the air pressure too low in my Smart MED iBreeze Medical Equipment mask?
If the air pressure in your Smart MED Medical Equipment mask feels too low, the Ramp function may be in progress. Either wait for the air pressure to build up or turn off the Ramp Time feature.
What to do if my Smart MED iBreeze Medical Equipment water chamber is leaking?
If your Smart MED Medical Equipment water chamber is leaking, check if it's assembled correctly and inspect it for any damage or cracks. If damaged, contact your care provider for a replacement.
Why does my Smart MED Medical Equipment keep blowing air after stopping therapy?
If your Smart MED Medical Equipment continues to blow air after you've stopped therapy, it's likely cooling down to prevent condensation in the air tubing. It will stop automatically after a few minutes.
How to fix erratic display on Smart MED iBreeze?
If your Smart MED Medical Equipment display is acting erratically, unplug the device and then plug it back in. If the problem persists, contact your home care provider.
Identifies conditions where CPAP therapy may be inadvisable or require caution.
Highlights critical safety warnings and cautions for device operation and use.
Procedure for filling the water chamber for humidification.
Instructions for initiating and concluding CPAP therapy sessions.
Guide to adjusting comfort settings like Preheat, Ramp, and Auto Start.
Explanation of different alert categories, their indicators, and potential causes.
Instructions for cleaning the exterior of the CPAP device.
Guidance on cleaning the breathing tube and water chamber.
General| Category | Medical Equipment |
|---|---|
| Pressure Range | 4-20 cmH2O |
| Humidification | Integrated heated humidifier |
| Automatic Altitude Adjustment | Yes |
| Leak Compensation | Yes |
| Warranty | 2 years |
| Therapy Modes | CPAP |
| Data Storage | SD Card |
| Power Supply | 100-240V AC, 50/60Hz |
| Type | CPAP/BiPAP machine |
| Battery Life | Optional external battery available |
| Operating Conditions | 5°C to 35°C |
To Next Page
