INSTALLATION
Connect one end of the supplied DSL cable to the port labeled DSL on the gateway
and connect the other end t the DSL wall jack installed by your provider.
For all other devices, connect an Ethernet cable from that device to any of the
LAN ports on the gateway.
Plug the power cord into the wall outlet and into the power jack on the back of
the gateway. For additional protection, connect the power cord to a surge pro-
tector.
Turn on the unit by pressing the power button on the gateway.
Your gateway is now automatically being set up to connect to the Internet.
This process may take a few minutes to complete before you can begin using
your Internet applications (browser, email, etc.). If you are unable to connect
to the Internet, verify that all cable connections are in place and that the
router’s power is turned on.
To Next Page
Loading...
