Smart Solar AquaNura LP User Manual

1
AquaNura LP Solar Birdbath Kit
0°C /32°F


Configuration and Assembly
We recommend the water be regularly topped off and changed to ensure it remains
clean and free from debris. Shallow birdbaths require more frequent filling due to
evaporation or the pump will run dry, which may cause damage
Frost causes damage and is not covered by warranty. Empty water and store
product inside during cold weather. For safety, we recommend doing this when the
weather is going to dip below 40°F.
Unit includes:
Solar panel housing x 1
Pump x 1
Fountain head set x 1
Extension Tube x 1
The AquaNura LP functions much like our original larger AquaNura but is designer to fit into
smaller, shallow birdbaths. This unit can still be used in a large deeper birdbath and there
will simply be more water sitting on top of the solar panel. We have included a 1” extension
tube for use in deep birdbaths to elevate the fountain heads above water.
In strong sunlight in a small birdbath or
during windy conditions, the pinhole
fountain head shown may cause water to
spray outside of the birdbath. Only use
this fountain head in the right conditions to
ensure your birdbath does not lose water.
* Birdbath not included
Warning! Important! Read Me!
Pump
1” Extension tube
Fountain head set
Pinhole
Bubbler


Smart Solar AquaNura LP Specifications

General

Output Waveform	Pure Sine Wave
Cooling	Fan Cooling
Device Category	Inverter
Input Voltage	12V DC / 24V DC / 48V DC
Output Voltage	110V AC / 220V AC
Continuous Power	1000W
Peak Power	2000W
Efficiency	≥90%
Protection Features	Overload, Over Voltage, Short Circuit, Over Temperature
Operating Temperature	-10°C to 50°C

Summary

AquaNura LP Solar Birdbath Kit Configuration and Assembly

Important Warnings and Recommendations

Setup and Operational Guidance

Performance Characteristics and Conditions

Pump Maintenance and Manual Start Procedures

Product Maintenance and Care

Troubleshooting and Customer Support