Do you have a question about the Smart water SW900 and is the answer not in the manual?
Connect the water sensor cable to the Tank Sender and attach the antenna.
Connect power and antenna to the LCD Keypad for setup.
Pair the Tank Sender with the LCD Keypad by pressing the connect button.
Set the approximate height of your water tank for accurate calibration.
Lower the sensor to the bottom of the tank and position the sender for optimal solar charging.
Connect the antenna and power to the WiFi Gateway for network setup.
Key considerations for optimal wireless performance and proper component installation.
Information on tank sender communication, error codes, and pump controller status.
| Brand | Smart water |
|---|---|
| Model | SW900 |
| Category | Water Heater |
| Language | English |