EasyManua.ls Logo

SMART BCD Series - Safety Instructions

SMART BCD Series
24 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAFETY INSTRUCTIONS
3
ATTENTION
Do not use the refrigerator if it is visibly damaged.
Do not block the refrigerator openings with things such as pins,
wires, etc.
Do not expose the device to rain or other wet conditions.
Do not place the appliance near open flames or other heat sources
(heaters, direct sunlight, gas ovens, etc.
Do not store explosive substances, such as spray cans with a
flammable propellant.
Make sure the power cord is dry and not trapped or damaged. Do
not locate multiple portable sockets or portable power supplies at
the rear of the appliance.
Check that the voltage specification on the type plate corresponds
to that of the power source. The appliance must only be used with
the power supply unit supplied with the appliance.
Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
Once unpacked and before starting, the appliance must be placed
on a flat surface for more than 6 hours.
Make sure the appliance remains horizontal when operating. The
tilt angle should be less than 5° for a long time and less than 45° for a
short time.
Keep the ventilation openings in the unit casing or built-in
structure clear of obstructions.
Keep the device stable on the ground or in the car; Do not drain
the device, upside down.
CAUTION
Repairs may only be carried out by qualified personnel. Incorrect
repairs may cause danger. The lamp and power cord must be
replaced by the manufacturer or qualified persons.
Installation of DC power in the boat must be carried out by
qualified electricians.