Once the tester is connected the current measured battery voltage is displayed for approx. 2 s. If a
so-called "System noise" is detected by the tester, check whether all consumers are switched off and
wait (for approx. 2 min), until the quiescent current is minimized and the bus systems are switched
off.
Fig. 7: View Of Clip Tester
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
2. Follow the menu and select according to the situation:
l In vehicle (battery connected to on-board electrical system)
l Not in vehicle (battery disconnected from on-board electrical system)
Confirm selection with "Enter".
2010 Smart Fortwo Passion
2009 ACCESSORIES & BODY, CAB Electrical System, Equipment & Instructions - Fortwo (Cabrio)
15 октября 2019 г. 19:12:10 Page 16 © 2011 Mitchell Repair Information Company, LLC.
To Next Page
Loading...
Need help?
General
