p)
Mount the boom fork on the mast by full mainsail and fix the boom
kicker with the karabiner in the eyelet guide provided on the boom (45
- 47)
Pull the boom kicker to have the mast bended. This pre bending of the
mast brings a higher performance and stability of the mast. The main
sail should have the same distance to the mast over the whole length.
q)
Now push the rudder from below into the holder provided on the rear
frame member, guide the tiller through the rudder mounting and fix this
with the spring cotter. The spring cotter is in the repair kit (packed in the
orange container) (48).
Position the spring cotter so that its lower end disappears into the
vertical tube of the rudder and is not
visible (49).
To Next Page