SECOND AND SUBSEQUENT ASSEMBLY
If you have taken the smartkat apart properly, you haven’t unlaced the
side frame tubes but have just loosened and perhaps unlaced the rear
frame tube so that you must only slot the side frame tubes into the front
frame tube and push on the rear frame tube. Now you can re-lace the
trampoline rope at the rear again and pull it tight. This saves you a lot of
assembling time.
e) After building the trampoline completely, turn it round again and slide
the inside and then the outside metal feet of the frame into the pockets on
the hulls. Take care that the sides of the hulls where the air valves are
situated are at the back and that the air valves point inwards. Do not use
force – the feet should slide easily into the pockets when you bend the
pockets up a bit. When all eight feet have slid into their pockets, you can
inflate the hulls fully. On new hulls, you will probably have to bend the
pockets up a little. After fixing all eight feet on the hulls, pump up both
hulls using the manometer supplied to check that the operating pressure
of 0.3 bar is achieved (10 - 15) .
To Next Page
Loading...