smartmi Rainforest - Using the Humidifier; Device Setup and Filling

05
Installation
Filling the Device
Power on/Standby
Press the Power on/Standby button on the back of the
unit to power the device on/switch to Standby mode.
Bring the unit and water tank points into alignment and
install the unit as shown in the picture. Plug in the power
adapter to power on the device.
Tip: Keep the unit upright.
Pure water is recommended to avoid scaling.
Use
Fill the water tank up to the high water level (the MAX line)
as shown in the picture on the right .
the MAX line