8. Display Panel Controls
On/Off
Press ON/OFF to start the display and power up
the bike.
To turn off, press the ON/OFF again.
Note: the display will power off after 5 minutes
without use.
Lights
Press to turn lights on and off.
Walk-along Feature
Hold 6kph for 2 seconds to enter into the mode
of power assist walk. The e-bicycle will go on
at a uniform speed of 6km/h until you let go of
pushing the button
Your display is easily controlled with 3 buttons located
on your handlebars.
MODE
6km/h
Pedal Assist
Press mode button, it shifts between 20%, 40%,
60%, 80%, 100%, 20% meaning low assistance from
motor, 100% meaning full assistance from motor.
The higher %, the more assistance. The default
mode is 20%.
You will notice that after one turn of the pedals the
motor will start working, assisting you to ride the
bike by adding power to the front wheel. This is the
standard or pedelec mode. To continue using the
pedelec mode you must keep turning the pedals; if
you stop the motor will stop and the bike will slow to
a halt. If you start pedaling again after one turn the
motor will start again.
Depending what country you are in, your throttle will
have different functionalities. In EU and Australasia,
It will work to 6kph unassisted, then only function
above that if you are pedaling. In other countries
it will be fully active whether you are pedaling or
not. If the bike is turned on, always be careful when
mounting the bike that you do not twist the throttle,
as the bike can accelerate away from you and cause
injury. Note: your brake levers have sensors that
will automatically cut motor power when you use
the brakes and restore it when you release the brake
levers.
8. Display Panel Controls
To Next Page
Loading...
