To Prepare
We recommend that you familiarise yourself
with the bike parts before assembling. Gather all
required tools. Be sure to work in a clean, dry space
with plenty of room. You might wish to lay down a
tarpaulin or old blanket to protect the bike during
assembly. You may find it helpful to stand the bike
frame on a block or sturdy box under the battery
housing to work with it in an upright position.
Please watch the balance when installing wheels.
1. Unpack
a. Carefully lift the electric bike out from the carton
(two people recommended for this task). Cut the
nylon zip ties with suitable scissors and remove the
foam protection from the bike.
b. Unfold the main frame until the hinge joint is fully
closed and lock it by pushing alloy lock lever until
it clamps against the frame. Then rotate the plastic
secondary lock down into the alloy lock lever.
The Vista electric bike is shipped folded inside the
carton and 95% assembled. Follow these steps to get it
ready and safe for you to ride.
2. Assembly Instructions
Vista
2. Handlebars
a. Carefully unfold the handlebar stem post up into
its vertical position, then close the alloy lock lever
against the stem post. The lock lever will be locked
automatically.
b. Adjust the handlebar horizontal rotation if
needed loosening the handlebar stem bolts, then
twist the handle bar to the correct angle and then
tighten back up.
Adjust the vertical height of handlebar opening the
quick release lever out on the mid section of the
stem post, then when adjusted tighten back up by
pushing the lever in.
2. Assembly Instructions
Vista
To Next Page
Loading...
