b. Table 1). Pump speed can be calculated by multiplying the engine RPM by the
PTO ratio. Adjust the engine speed or PTO ratio if necessary.
c. The generator speed may be incorrect. The generator output should be between
59-62 Hz for 60 Hz application or 49-52 Hz for 50 Hz application. If it is not,
contact Smart Power
®
Systems at (231) 832-5525 for further instructions.
d. If the problem is not detected by performing steps a. through c., contact Smart
Power Systems
®
.
3. Generator Noise:
Generator noise can be caused by defective generator bearings or a faulty
generator/hydraulic motor coupling.
a. Contact Smart Power Systems
®
if bearings need replacement.
b. Check the generator/hydraulic motor coupling and replace it if necessary.
If problems occur other than those listed call Smart Power Systems
®
(231) 832-
5525 for additional assistance.
To Next Page
Loading...