Options and Accessories
502-3501 Users Guide and Programming Software - Complete
documentation and PC-DOS programming software required for
installing, aligning and programming the ST-853 controller. One P/N
502-3501 is required for each system.
ST-910 CTCSS Decoder Option - A miniature CTCSS decoder which
may be added to the ST-853 controller to provide additional protection
from intermod or co-channel interference. Recommended for use in
the United States and other areas of high RF activity or where there is
possible interference from a distant repeater on the same channel.
ST-911 Cable Assembly Option - A 4’ long (122cm) shielded cable
assembly terminated with a DB-25 connector which mates to the ST-
853. Provides all the connections necessary between the ST-853 and
the host repeater. Note: A DB-25 connector kit (without cable) is
provided with each ST-853.
ST-956 External Modem and Cable - An external high speed modem
and interface cable used to program an ST-853 site remotely over a
telephone line (if remote access is desired). This option may be used
to install a modem at the site (only one modem required per site) or at
the local computer used for programming.
18
System Overview
To Next Page
Loading...