-11-
SMARTWARES SAFETY & LIGHTING
Can never be held liable for loss and / or damages of any kind,
including incidental and / or consequential damages arising out of
the fact that the signal from the smoke alarm device is not triggered
by smoke or fire.
Errors are indicated by the following:
1. The alarm does not sound when pressing the test button.
* Carefully vacuum the smoke alarm device (see Cleaning), test
afterwards. Still no reaction; replace smoke detector
2. The smoke alarm device “chirp” with red LED flashes once
every 40 sec.
* The battery is under low battery status, please replace the
smoke alarm device; battery is not replaceable.
3. Smoke alarm device “chirp” occurs every 40 seconds
(alarm goes into fault mode)
* Clean smoke alarm device. Please refer to maintenance
section. When problem is not solved replace smoke alarm
device.
4. Smoke alarm device sounds unwanted alarms intermittently or
when resident are cooking or taking showers.
* Press test button to pause alarm.
* Clean smoke alarm device (maintenance section)
* Move smoke alarm device to other place and press test button
>>>
TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
