English - 35/10234/102 - English
SMASH 43 SMASH 43
6.1.LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Machine
• Protector
• Handlebar
• Tools
• Cutting accessories
• Harness
• Instruction manual
Ensure that all elements listed above are included with
the machine. Thanks to the quality control checks at
the factory it is highly unlikely that any elements will
be missing. If you were to find any element missing,
do not use the machine until the defect has been
repaired or the machine is complete.
Using the machine with defective parts or without all
the elements can cause severe personal damages.
6.2. MOUNTING THE MACHINE
6.2.1.INSTALLATION OF THE HANDLEBAR
6.2.2 GUARD SUPPORT ASSEMBLY
The skirt of the protector must not be worn when
working with the cutting disk.
The transmission can be locked by inserting a tool or
screwdriver through the transmission hole and the
notch on the plate (3).
6. START UP INSTRUCTIONS
Protector
Protector flap
Guard support
Support
To Next Page
Loading...