SMC Networks D3CM1604 - Configuring an Apple Macintosh Computer

Preconfiguration Guidelines
31
D3CM1604 DOCSIS 3.0 Cable Modem Administrator Manual
Configuring an Apple
®
Macintosh
®
Computer
The following procedure describes how to configure TCP/IP on an Apple Macintosh running
Mac OS 10.2. If your Apple Macintosh is running Mac OS 7.x or later, the steps you perform
and the screens you see may differ slightly from the following. However, you should still be
able to use this procedure as a guide to configuring your Apple Macintosh for TCP/IP.
1. Pull down the Apple Menu, click System Preferences, and select Network.
2. Verify that the NIC connected to the D3CM1604 is selected in the Show field.
3. In the Configure field on the TCP/IP tab, select Using DHCP (see Figure 3-8).
4. Click Apply Now to apply your settings and close the TCP/IP dialog box.
Figure 3-8. Selecting Using DHCP in the Configure Field