1. WARRANTY
Warranty pertaining to your Telelight is explained in the Company’s separate
booklet entitled Registration & Warranty Information (RW1).
This booklet should be read in conjunction with these operator’s guidance
notes.
2. WARNING & SAFETY INSTRUCTION
Failure to follow the warning instructions could result in severe injury or death to
the operator, a bystander or a person inspecting or repairing the machine.
2.1 WARNING
Operators should be trained in the safe use of the Telelight. If training has not
been carried out this should be reported to to your designated Company safety
officer. Do not operate the Telelight unless trained in its safe use.
Voltage used in this equipment can endanger life. Before attempting
replacement of components or maintenance operations, ensure that any power
supply and the generator are switched off.
The engine and generator set comprises components and fluids that, in
operation, are subject to high temperature. Caution is required to avoid burns
and scalding.
The Telelight is equipped with moving parts, pulleys & belts. Be careful in the
vicinity of the machine and avoid wearing loose clothing.
In case of fire do not use water. Use only an appropriate fire extinguisher.
Do not operate the Telelight in poorly ventilated areas, as exhaust gasses can
be extremely dangerous/fatal.
2.2 SAFETY INSTRUCTIONS
For safety operation observe the following instructions:
Exhaust gases
The exhaust gases contain harmful carbon monoxide. Operate the Telelight in
a spacious, well ventilated, area.
Electric shock prevention
Never touch the Telelight with wet hands.
IMPORTANT: Ensure the Telelight is EARTHED correctly.
3
To Next Page
Loading...
Need help?
General