SME 3012-R User Manual

1204 1205
Fitting the balance weight
Ag
$uppted
the
balance
and
ndar
weight
assembly
9
packed
Separately
BN 1 Gonweneeant to fit therm at thes Slage
1204
The
lnadscrew
follower
control
on
the
side
of
the
main
balance
WENght
Mmowes
outwards
2
itis
folated
and
should
be
in
this
Postion
for fitting
1205 Side
the
balance
and
nder
wmght
assembly
on
to
the
tone-amm
exteansian
1206
1207
1206 SURpOTt the ras WG So Thal the way-red m@ horizontal i PT
Wowie
from
the
near
Ratate
the
leaden
follcwaner
control
nite
ihe
Bosrtion that well allow it ta move inwards through the slot in the
fone-arm extension. Slight rotation of the main balance waight one
Way or ihe other will asset the loadscrew follower to enter the slot
and Pass into Bnqugement wath tho laden
W207 The COmplete mubn balance pnd ricer wetgnt aas5ombly caters for
cartndges in the range 13-26 grams It i on two parts and the front
may be detached by rotating and wathdrawing it from the mur
Weg
ht
When
this
has
been
done
the
range
covered
is
14
1d
Tare:
1208 1209 1210
Fitting the arm
1208 Insert the four woodscrews through the grommets in the bedplate
and screw partly home. As daivwarad the arm height is adjusted to
Suit its pack. It may therefore be necessary at this point to re-adjust it
to clear the tumtabla by reference to page 15 paragraphs 1233-12735.
1209 Tighten the woodscravws a5 shown
1211
1270 45 an alternative, hard mounting may be preferred. lt is then
1211
necessary to remeave the nuibber grommets from the bedplate ard ta
Place one of the steel washers under the head of each woodscrew
before inserting and fully tightening them
When the surface of the tunntable i more than 14° (413 mim) above
that on which the bedplate ig mounted, a spacer SME socessory Fl
iS nequired. lt is complete with woodserews. Nuts and balts arg also
available on request for fining to metal decks

SME 3012-R Specifications

General

Brand	SME
Model	3012-R
Category	Turntable
Language	English