Need help?Do you have a question about the SME 15 and is the answer not in the manual?
Covers risks of electric shock and prohibition of removing power unit or speed control unit covers.
Guidelines on ventilation, water avoidance, cable management, and electrical connections.
Details UK plug fuse, power cable colour coding, earth terminal warning, and WEEE disposal.
Ensures the main chassis is level using adjustable feet and a spirit/bubble level.
Details removal of transit screws for suspension and main bearing.
Instructions for placing and ensuring the drive belt is free from twists.
Guidance on carefully placing and securing the platter onto the spindle and driven pulley.
Adjusting the sub-chassis suspension height using a 3mm hex wrench to achieve proper clearance.
Connecting the power unit, speed control unit, and turntable using specified cables.
Securing the tonearm mounting plate and fitting the tonearm using cap screws.
Using jacking screws to facilitate the removal of the tonearm mounting plate.
Operating the power ON/OFF button on the rear of the power unit.
Starting and stopping the motor using the speed control unit fascia buttons.
Using the stroboscopic disc to check turntable speeds (33 and 45rpm).
Adjusting turntable speed incrementally using the rotary button and storing settings.
Moving the control lever to lower the stylus onto the record groove.
Returning the control lever to raise the stylus from the record.
Cleaning the drive belt and pulley peripheries with a soft tissue and lighter fuel.
Procedure for changing suspension bands and re-checking suspension height.
Fuse replacement should only be done by qualified service personnel.
Details conformity with EC directives for EMC and electrical safety standards.
To Next Page
General
