SME 15 - Power Unit & Speed Control Unit Connection

14
9. 
 Ifitisdesiredtoincreasesub-chassisisolaonbecauseofunusuallyclose
proximitytothespeakerstherecommendedsuspensionheightclearance
of 3.5mm can be reduced to 2mm. This lowers the spindle/bearing
housingdeeperintothedampeningbathandsubsequentlyincreasesthe
dampeningacon.
6. Power Unit & Speed Control Unit
 Thepowerunitisconnectedtothespeedcontrolunitandturntableby
wayoftheconneconcables(Secon16)withLEMO connectors.The
cablescannotbeconfusedastheycarryadierentnumberofpinswhich
arepurposelyconguredtoobservebothsafetyandmiss-idencaon.
ThecablesareidenedasAandB.
 1. ConneconCableA-PowerUnitOutputtoSpeedControlUnitInput
 2. ConneconCableB-SpeedControlUnitOutputtoTurntableInput
 The AC mains power cable is connected to the power unit AC input.
A push ON/OFF switch is located on the rear of the power supply unit.
IMPORTANT
 Themainsvoltagesengisindicatedontherearpanelofthepowerunit.
Beforengthe mains power cable check carefullythatthismatches
yourmainsvoltage.