Smeg 50's Style Series User Manual

Use
36
Setting the time for the AUTO START mode
This setting allows the appliance to be
programmed to switch on automatically to
brew the drip coffee at a time selected by
the user.
To set the time at which the appliance
switches on automatically, proceed as
follows:
1. Make sure that the time displayed is
correct. Otherwise, set the correct time
as described in section ”3.2 First use”.
2. Press and hold the button for 3
seconds to set the automatic start time
mode AUTO START: The LED of the
button and the time display (HH:MM)
start to flash.
3. Move the lever up (+) or down (-) to set
the time.
4. Confirm the time by moving the lever to
the central position and press (OK).
If the sounds are enabled, the appliance
will beep to confirm that the setting has
been saved.
5. Once set, the time for the AUTO START
function will be saved automatically and
will be used until it is modified.
AUTO START mode
1. Press the AUTO START button to
start the AUTO START mode: the LED of
the AUTO START button will light up
and the hours and minutes of the set start
time for brewing the coffee will flash for a
few seconds on the display. Then the
current time will then be displayed.
2. Press the AROMA button to select
the intensity of the coffee required for the
AUTO START mode. If necessary,
depending on the quantity to be brewed
in AUTO START mode, press the
4 CUPS function button to memorise
the function.
3. The appliance remains in AUTO START
mode until the pre-set time, a beep will
indicate that the brewing cycle has
started automatically.
4. Press the AUTO START button at
any time to exit from the AUTO START
mode.

Smeg 50's Style Series Specifications

General

Anti-drip Spout	Yes
Non-slip Feet	Yes
Cord Storage	Yes
Safety Lock	Yes
Reverse Function	Yes
Color Options	Cream, Black, Red, Pastel Blue, Pastel Green
Category	Juicer