22
EN
5 Maintenance and cleaning
Service life of the product extends and
frequently faced problems decrease if
cleaned at regular intervals.
B
This product must be unplugged
during maintenance and cleaning
works (control panel, body, etc.).
Lint Filter / Loading Door Inner
Surface
Lint and fibres released from the laundry
to the air during the drying cycle are
collected in the Lint Filter.
C
*Such fibre and lint are generally
formed during wearing and washing.
A
Always clean the lint filter and the
inner surfaces of the loading door
after each drying process.
C
You can clean the lint filter housing
with a vacuum cleaner.
To clean the lint filter:
1. Open the loading door.
2. Remove the lint filter by pulling it up
and open the lint filter.
3. Clean lint, fibre, and cotton raveling
by hand or with a soft piece of cloth.
4. Close the lint filter and place it back
into its housing.
C
A layer can build up on the lint filter
pores that can cause clogging of the
lint filter after using the machine for a
while. Wash the lint filter with warm
water to remove the layer that builds
up on the lint filter surface. Dry the lint
filter completely before reinstalling it.
C
Clean the entire inner surface of
the loading door and loading door
gasket.
Cleaning the sensors
To Next Page
Loading...
