EN / 18
8 Use of Your Appliance
8.1 Setting the Operating Temperature
1 Green Indicator 2 Red Indicator
3 Thermostat Knob
LED Indicators and Control Panel
Inside the appliance there are two coloured
indicator lights that show the operating
mode of the freezer.
Green Indicator (1):
It comes on when the appliance is connec-
ted to the mains and stays on as long as
there is power. If the thermostat is set to '0',
the green light will not switch on. The green
indicator does not give any information
about the temperature inside the freezer.
To turn off the product (position 0), please
rotate the button with a little more force.
Red Indicator (2) Lights in the following
cases:
a) The preset temperature cannot be main-
tained.
b) If an excessive amount of fresh food is
placed inside.
c) If the door of the appliance is accident-
ally left open.
Thermostat Knob (3):
The thermostat switch is located above the
indicator light set.
The operating temperature is set by the
temperature control.
1 = Lowest cooling setting
4 = Highest cooling setting
(or)
Min. = Minimum cooling setting
Max. = Maximum cooling setting
Please select a setting based on the de-
sired temperature.
The internal temperature also depends on
the ambient temperature, the frequency
with which the door is opened and the
amount of food stored inside.
Frequent opening of the door causes the in-
ternal temperature to rise.
Therefore, it is recommended that you
close the door as soon as possible after
use.
The normal storage temperature of your
unit should be -18°C (0°F). If the thermostat
knob is turned counter-clockwise from pos-
ition 1, the appliance will switch off and a
"click" will be heard. Lower temperatures
can be achieved by moving the thermostat
knob towards position 4.
We recommend checking the temperature
with a thermometer to ensure that the stor-
age compartments are at the desired tem-
perature.
Remember to read the temperature imme-
diately after removing it from the freezer,
as the thermometer temperature rises very
quickly.
Freezing food
The freezing area is marked with a ° symbol
on the door plating.
EN
FR
DE
IT
To Next Page
Loading...
