User instructions
If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
• Alarms
E1, E3, E4
interrupt the current program immediately.
• The
E5
,
E6
alarms interrupts the running program once the cause is
resolved, it will bring bach the execution of the program.
To “reset” an alarm is necessary:
• Open and close the door, or turn off and on the machine. At this
point is possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.
To Next Page
Loading...
Need help?
General
