UK - 4 -
Before Switching On
• Wait after 3 hours before plugging the appliance in to the main power
to ensure proper performance.
• There can be an odour when you first switch on the appliance. It will
disappear after the appliance starts to cool.
Installation and Switching On The Appliance
• This appliance is connecting to 220-240V or 200-230V and 50 Hz. Please check
nameneplate of appliance and be sure voltage range suitable to your mains volt-
age.
• You can offer help from the service to install and switching on the appliance.
• Before making the connection to the power supply,ensure that the voltage on the
name plate corresponds to the voltage of electrical system in your home.
• If the socket does not match the refrigerator plug, replace the plug with a suitable
one (at least 16 A)
• Insert the plug into a socket with an efficient ground connection.
If the socket has no ground contact or the plug does not match,
we suggest you to call an authorised electrician for assistance.
• The plug should be accessible after the appliance is positioned.
• Manufacturer is not responsible for failure to complete the
ground connection as described in this booklet.
• Do not place the appliance in direct sunlight.
• Do not use in open air and shall not be exposed to the rain.
• Place the refrigerator far from heat sources and in a well-venti-
lated position. The refrigerator should be at least 50 cm from
radiators, gas or coal stoves and 5 cm far from electrical stoves.
• Keep the top free for at least 15 cm.
• Fit the plastic wall spacers to the condenser at the back of the
refrigerator in order to prevent leaning to the wall for good per-
formance.
• Do not place heavy and lots of things on the appliance.
• If the appliance is installed next to another refrigerator or freezer,
observe a minimum distance of 2 cm to prevent condensation.
• The appliance must be stand firmly and level on the floor Use
the two front levelling-feet to compensate for an even floor.
• The outside of the appliance and the accessories inside should be cleaned with a
solution of water and liquid soap; the inside of the appliance with sodium bicarbon-
ate dissolved in lukewarm water. After drying replace all the accessories.
To Next Page
Loading...
