EN
23
Filing the water tank
Remove the top cover of the water tank.
Fill up the tank with water.
Mount back the top cover of the water tank.
Attention
If you leave water in the tank for a long time it could cause
odour. In this case clean the tank and keep using it.
Cleaning the Water Tank
Lift the water tank.
Remove the tank cover with upholding the side locking
covers.
Clean up the tank with warm water and reassemble the
pieces you removed.
Stowing the Water Tank
Install the water tank as shown.
Be careful about the tap and the hole match each other
while installing.
its place properly. Also check the gaskets are assembled
properly.
Drip Tray
During the usage of dispenser the water splashes around
the glass piles up in the drip tray. In order to clean it remove
the tray. After the cleaning you can mount it on.
Filter detail
Do not use this related cover.
related detail.
Please apply to authorized service center about opening of
USAGE INFORMATION
To Next Page
Loading...
