Instructions for Use26
Placing and Installation
Choosing the Right Place
Place the appliance in a dry and regularly
ventilated room. Allowed ambient temperature
depends on the model (class) of the appliance
and is stated on the rating plate of the
appliance.
Never place the appliance near heat emitting
devices (e.g. cooker, radiator, water heater or
similar devices) and do not expose it to direct
sunlight.
The appliance should be positioned at least 3
cm away from the electric or gas cooker and at
least 30 cm away from the oil or coal stove. If
this is not possible, use an appropriate
insulation.
Behind the appliance there should be free
space at least 200 cm² wide and above the
appliance the high kitchen units should be at
least 5 cm away from the appliance in order to
assure adequate ventilation of the condenser
unit.
Class Ambient temparature
SN (sub-normal) from + 10°C to + 32°C
N (normal) from + 16°C to + 32°C
ST (sub-tropical) from + 16°C to + 38°C
T (tropical) from + 16°C to + 43°C
Connection to Power Supply
Connect the appliance with the cable and plug
to the power supply socket outlet with a ground
terminal (safety socket).
Required nominal voltage and frequency are
indicated on the rating plate.
The connection to the mains supply and
earthing have to be made according to current
standards and regulations. The appliance
resists temporary voltage tolerance up to -6%
to +6%.
Description of the Appliance
Shelf (1)
(the number of shelves depend on model)
Shelf can be optionally placed on the guides
inside the appliance. It is protected against
pulling out. If you want to remove it, slightly lift
up the back part and pull it out.
Glass shelves (some models only have them)
are protected with plastic spacers. Before
pulling the shelf out, spacers must be moved
towards you. Spacers can be also removed,
however, it is better to keep them for any later
transport. Quickly perishable food should be
stored on the back i.e. the coldest part of the
shelves.
To Next Page
Loading...
