Installation
47
5 Installation
1. This appliance is only intended for
domestic use.
2. This oven is intended for built-in use only.
It is not intended for counter-top use or
for use inside a cupboard.
3. Please observe the special installation
instructions.
4. The mains voltage must correspond to
the voltage specified on the rating plate.
5. The socket must be installed and
connecting cable must only be replaced
by a qualified electrician. If the plug is no
longer to accessible following
installation, an all-pole disconnecting
device must be present on the installation
side with a contact gap of at least 3mm.
6. Adapters, multi-way strips and extension
leads must not be used. Overloading
can result in a risk of fire.
High temperatures inside the oven
after use
Danger of burns
• The accessible surface may be hot
during operation.
To Next Page
Loading...
