Why is there excessive build-up of ice on the back wall of my Smeg Fridge-freezer?
Excessive ice build-up on the back wall of your Smeg Refrigerator can occur if the door is opened too often or left open too long, warm food was placed inside, food or a container is touching the back wall, or the door seal is not working properly. If the seal is dirty or damaged, clean or replace it.
Why is my Smeg Refrigerator cooling system running constantly?
Your Smeg Refrigerator's cooling system might run constantly due to several reasons. The ambient temperature could be too high, or the door may be opened frequently or left open too long. Also, the door might not be closing properly because of a particle between the door gasket, a sagged door, or a faulty gasket seal. An excessive amount of fresh food inserted at once or food blocking air circulation around the probe can also cause this. Make sure there is sufficient air circulation for the compressor and clean the condenser.
What to do if my Smeg Fridge-freezer is dripping water?
If water is dripping from your Smeg Refrigerator, it might be due to a clogged drain outlet. Try cleaning the outlet using a plastic straw. You may also need to manually thaw thick ice deposits.
What to do if water is dripping from my Smeg Fridge-freezer?
If water is dripping from your Smeg Refrigerator, it could be due to a blocked water discharge opening, or water from thawed ice dripping past the water collection trough. Try cleaning the blocked opening using a plastic straw. Additionally, if the layer of ice is too thick, defrost the appliance annually.
How to troubleshoot a Smeg Refrigerator that won't turn on?
If your Smeg Refrigerator is not operating after connecting it to the power mains, ensure that the wall outlet is powered and that the appliance is properly plugged in.
How to replace the light bulb in my Smeg Fridge-freezer Refrigerator?
Before replacing the bulb in your Smeg Refrigerator, disconnect the appliance from the power mains. Remove the cover using a screwdriver, replace the bulb with a new one (E14, same power rating as the original), and then replace the cover. Remember not to dispose of the blown bulb with organic waste, and note that the bulb is excluded from the warranty.
What to do if my Smeg Refrigerator does not operate after connecting to power?
If your Smeg Refrigerator isn't working after you've plugged it in, check that the socket has power and that the appliance is switched on.
How to replace the light bulb in a Smeg Fridge-freezer Refrigerator?
Before replacing the light bulb in your Smeg Refrigerator, disconnect the appliance from the power supply. Use a screwdriver to press the locking hook and remove the cover. Insert the screwdriver into the cover slot, lift it and remove the cover. Replace the bulb with an equivalent new bulb (E 14, same voltage as the original one) and replace the cover back to its position.
Why won't my Smeg Fridge-freezer Refrigerator door open easily?
If you experience strong resistance when trying to open the Smeg Refrigerator freezer door immediately or shortly after closing it, this is due to a build-up of sub-pressure. When the door is opened, cool air escapes and is replaced by warm air, which then cools down, creating resistance. This condition normalizes after a few minutes, allowing the door to be opened easily again.
Why is my Smeg Fridge-freezer Refrigerator cooling system running continuously?
If your Smeg Refrigerator's cooling system runs continuously for a long time, it could be due to several reasons. The environment temperature might be too high. The door might be opened too often or left open too long, or it is not closed properly because of dirt, a tilted door, or a faulty seal. Too much fresh food might have been inserted, or the sensor might be blocked by food (on some models). Check the air circulation behind the appliance and clean the condenser if there is insufficient compressor and condenser cooling.
General| Brand | Smeg |
|---|---|
| Model | Fridge-freezer |
| Category | Refrigerator |
| Language | English |
Electrical connection and grounding instructions.
Explanation of control panels and their functions.
Procedure for powering the appliance on and off.
Guide to setting temperatures for compartments using Units I/II.
Description of controls for dual compressor system.
Steps and tips for freezing fresh food.
Manual steps for defrosting a conventional freezer.
To Next Page
