Smeg KDD90CNE - Remote Control

11
4. CONTROLS
Button Function LED button
A
The button only works when the door is open.
Turns the motor On/Off at speed one.
-
Press and hold the button for approximately 5 seconds, with all the
loads turned off (Motor and Lights), to turn the Remote control On/Off.
IR+Dot (Flashes twice)-Remote control On.
IR+Dot (Flashes once)–Remote control Off.
B
Press Briey = Turns the Lights On/Off at maximum intensity. -
Press and hold for 2 Seconds = Turns the Courtesy Lights On/Off. -
C
The button only works when the door is open.
Activates / Deactivates the 24h function which turns the motor on at
speed one for 10 minutes every hour, for 24 hours.
At the end of this time the hood turns Off.
Visualizza un’animazione.
D
Only works with the Door Open = decreases the operating speed.
Speeds P1 - P2 are the 2 intensive speeds, which are set to:
P1 = 5 minutes and P2 = 7 minutes
At the end of this time the motor returns to speed two.
Displays the set speed:
P2 – P1 – 3 – 2 – 1
E
Only works with the Door Open = increases the operating speed.
Speeds P1 - P2 are the 2 intensive speeds, which are set to:
P1 = 5 minutes and P2 = 7 minutes
At the end of this time the motor returns to speed two.
Displays the set speed:
1 – 2 – 3 – P1 – P2
Works both with the Door Closed and Open.
Press and hold for 2 Seconds = Enables/Disables the Activated Charcoal
Filter Alarm with the Motor turned off and no Filter Alarm triggered.
C ashes twice = A.C. Filter Alarm Activated
C ashes once = A.C. Filter Alarm Deactivated
F
Only works with the Door Open.
Activates/Deactivates the Delay, automatic switch-off of the motor
with a 15’ delay.
When this function is activated the motor is set to speed one. If
the function is deactivated before the time foreseen, the motor will
remain at speed one.
Displays L
G
Works both with the Door Closed and Open.
Press and hold for 2 Seconds = With the lter alarm triggered the
Filter Alarm is Reset. These indications are only visible when the
motor is turned off.
Displays Indicates the need to wash the metal
grease lters. The alarm is triggered after the Hood has
been in operation for 100 working hours.
Displays Indicates the need to change the
activated charcoal lters, and also to wash the metal
grease lters. The alarm is triggered after the Hood has
been in operation for 200 working hours.
H
Door Closed
Opens the door and Motor + Lights = On.
-
Door Open
Closes the door and Motor + Lights = Off
-
5. REMOTE CONTROL
(OPTIONAL)
6. LIGHTING
• For replacement contact technical
support (“To purchase contact technical
support”).