Smeg KTS75 - Installation of Glass Panels; Install First Glass Panel; Install Second Glass Panel; Glass Removal

Installation of glass panels
EN
01
Glass removal
To remove the glass panels, follow the procedure in the reverse order.
EN
02
Take the two 200x750 hood glass panels out
of the box.
Remove them from the box with care.
Open the hood upper glass panel (Fig.1).
Take the glass panel with the SMEG
logo close to the hood and centre the
four hinges in their seats (Fig.2).
Fig.3.1 - Initial position
(Pins high)
Fig.3.2 - Final
position
(Pins down)
Fig.1
Fig.2
Fig.3
Let the glass panel slide downwards
along the pin guides (Fig.3.2).
Get the glass panel with no logo and
place it near the hood
2
, centre the
four pins in the remaining four hood
seats (Fig.4).
(2) For proper positioning, check the position of
the metal frame on the back (Fig.4.1).
Let the glass panel slide along the
pin guides (Fig.5 and Fig.3.2)
Fig.4
Fig.5
Fig.4.1 – Rear
view.