User instructions
13
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “STARTING THE PROGRAM”. The program will resume from the
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
HALF LOAD WASH SETTING (certain models only)
(available in all programs except the soak program)
This function is ideal for small loads and saves water and electricity. It is
controlled by the HALF LOAD button (5) and allows washing in the
upper basket only.
IMPORTANT: at the end of the program remember to deactivate the
function to ensure the next wash is not also carried out in half load
mode by mistake.
A cutlery basket can be placed in the upper basket, while the lower
basket must be left empty.
CAUTION: there is no point in loading dishes and cutlery in the
lower basket, since the jet of water will only reach the upper basket.
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
• Always try to run the dishwasher fully loaded.
• Do not wash the dishes in running water.
• Use the washing program that is most appropriate for each type of
load.
• Do not carry out any preliminary rinsing.
• If available, connect the dishwasher to a hot water supply up to
60°C.
To Next Page
Loading...
