Smeg SACD82 - Suggested Solutions for Problems

Dryer / User Manual
27 / 28 EN
6 Suggested solutions for problems
Drying process takes too much time
• Meshesofthefiltermaybeclogged.Washwithwater.
Laundry comes out wet at the end of drying.
• Meshesofthefiltermaybeclogged.Washwithwater.
• Excessivelaundrymighthavebeenloadedin.Donotloadthedryerinexcess.
Dryer does not switch on or the programme does not start. Dryer is not activated when set.
• Itmighthavenotbeenpluggedin.Makesurethatthemachineispluggedin.
• Theloadingdoormaybeajar.Makesurethattheloadingdoorisproperlyclosed.
• Programmemighthavenotbeensetorthe"Start/Pause/Cancel"buttonmighthavenotbeenpressed.Make
sure that the programme has been set and it is not in “Pause” mode.
• "Childprooflock"mighthavebeenactivated.Deactivatethechildprooflock.
Programme has been interrupted without any cause.
• Theloadingdoormaybeajar.Makesurethattheloadingdoorisproperlyclosed.
• Electricitymaybecutoff.Press"Start/Pause/Cancel"buttontostarttheprogramme.
Laundry has shrunk, become felted or deteriorated.
• Aprogrammesuitableforthelaundrytypemighthavenotbeenused.Dryonlythelaundrywhichissuitablefor
drying in dryer after checking the labels on your clothes.
• Selectaprogrammewithsuitablelowtemperatureforthelaundrytypetodryyourclothes.
Drum lightning does not come on.
• Dryermighthavenotbeenstartedbyusingthe"On/Off"button.Makesurethatthedryerison.
• Bulbmayhaveblown.Calltheauthorizedservicetoreplacethebulb.
“Final / Anti-creasing” symbol flashes.
• The2-houranticreasingprogrammetopreventlaundryfromcreasingmighthavebeenactivated.Turnoffthe
dryer and take out the laundry.
“Final / Anti-creasing” symbol is on.
• Programmehascometoanend.Turnoffthedryerandtakeoutthelaundry.
Water comes out the cover.
• Cleantheentireinnersurfaceofthecoveranddoorgasket.
Cover opens spontaneously.
• Pushituntilyouhearthatitisclosed.
For products with a condenser:
“Water tank” warning symbol is on.
• Watermaybefull.
• Anti-creasingprogrammemightberunning.Drainthewaterinthetank.
“Filter cleaning” symbol is on.
• Filtermighthavenotbeencleaned.Cleanthecoverfilter.
“Condenser cleaning” symbol is on.
• Filterdrawer/Condensermighthavenotbeencleaned.Cleanthefiltersinthecondenser/filterdrawerunderthe
kick plate.
A
Call an authorised service if the problem persists.