Cleaning and maintenance
41
EN
4.9 Pyrolysis: automatic oven
cleaning
Preliminary operations
Before starting the pyrolysis cycle:
• Clean the internal glass panel following
the usual cleaning instructions.
• For very stubborn encrustations spray an
oven cleaning product onto the glass
(read the warnings on the product);
leave for 60 minutes, then rinse and dry
the glass using kitchen roll or a microfibre
cloth.
• Completely remove all accessories from
inside the oven.
• Remove the racks/trays support frames.
• Remove the roof lining (where present).
• Close the door.
Pyrolysis setting
1. Turn the function knob to symbol or
.
2. Press followed by .
3. Hold down and use or to set
the cleaning cycle time from a minimum
of 1 hour and 30 minutes to a maximum
of 3 hours.
Setting of programmed pyrolysis
The pyrolysis start time can be programmed
using the programmer clock.
4. After selecting the pyrolysis cycle
duration, press . The time when the
cleaning cycle will terminate will appear
on the display.
5. Press and hold and use or to
set the time at which you wish to
terminate the pyrolysis cycle.
Pyrolysis
6. Two minutes after the pyrolysis cycle has
started the door is locked (the door lock
indicator light comes on) by a device
that prevents the door from being
opened.
Pyrolysis is an automatic high-
temperature cleaning procedure
which causes dirt to dissolve.
Thanks to this process, it is possible
to clean the inside of the oven very
easily.
Improper use
Risk of damage to surfaces
• Remove any food residues or large spills
from previous cooking operations from
the inside of the oven.
• Switch off the burners or electric hot
plates of the hob installed above the
oven.
Recommended pyrolysis duration:
• Light dirt: 90 minutes.
• Medium dirt: 135 minutes.
• Heavy dirt: 180 minutes.
It is not possible to select any
function once the door locking
device has been activated.
To Next Page
Loading...
