Smeg SI1F7645B - Page 14

Incorrect cookware position:
Flexi4Zone big mode
To activate the mode press until you
see the correct mode indicator . This
mode connects three rear sections into
one cooking zone. The one front section is
not connected and operates as a separate
cooking zone. You can set the heat setting
for each zone separately. Use two left side
control bars.
Correct cookware position:
To use this mode you have to place the
cookware on the three connected
sections. If you use cookware smaller than
two sections the display shows and
after 2 minutes the zone switches off.
Incorrect cookware position:
Flexi4Zone max mode
To activate the mode press until you
see the correct mode indicator . This
mode connects all sections into one
cooking zone. To set the heat setting use
any of the two control bars on the left side.
Correct cookware position:
To use this mode you have to place the
cookware on the four connected sections.
If you use cookware smaller than three
sections the display shows
and after 2
minutes the zone switches off.
14