INSTALLATION - 3191477A765/A
with insulating silicone (B) and wipe off any
excess. If for any reason the hob needs to be
removed, cut the silicone using a cutter before
attempting to remove it (C).
Standard and Flush mounting (mm)*
* The image on the left shows the Standard opening, while the one on the right shows the Flush
opening.
Connection positions (mm)
Mounting
Over built-in oven unit
The clearance between the hob and the kitchen
units or other built-in appliances must be enough
to ensure sufficient ventilation and air discharge.
If installed above an oven, a space must be left
between the bottom of the hob and the top of
the appliance installed below.
It is also necessary to maintain a distance of
approximately 57 mm from the front panel of the
oven to the front of the appliance, as shown in
L (mm) X (mm) Y (mm) G (mm) H (mm)
300 490 270 - -
300 490 270 514 304
Electrical connection
See General safety instructions.
1 Opens on bottom
2 Opens on bottom and back
To Next Page