Why is there insufficient suction in my Smeg SPUM90X Ventilation Hood?
If your Smeg Ventilation Hood exhibits insufficient suction, it might be due to the distance between the hood and the gas top being too long, in which case you should readjust the distance. Another possible cause is too much ventilation from open doors or windows. To resolve this, consider choosing a new location and reassembling the machine.
What to do if my Smeg SPUM90X shakes?
If your Smeg Ventilation Hood's body is shaking, it could be due to several reasons. The leaf might be damaged, requiring a replacement. Alternatively, the motor might not be tightly secured, so ensure it is properly locked. Lastly, the body itself might not be tightly fixed, so ensure the body is tightly secured.
How to fix a Smeg SPUM90X Ventilation Hood when the light is on but the motor doesn't work?
If the light on your Smeg Ventilation Hood is on, but the motor isn't working, there could be several reasons. A leaf might be blocking the motor, so you should remove the blockage. The capacitor could be damaged, necessitating a replacement. Alternatively, the motor bearing might be jammed or damaged, or there may be an internal issue causing the motor to shut off or emit a bad smell, in which case you should replace the motor.
Why is my Smeg SPUM90X Ventilation Hood inclining?
If your Smeg Ventilation Hood is inclining, the fixing or hanging screws may not be tight enough. Tighten the hanging screw to ensure the hood is horizontal.
What to do if my Smeg SPUM90X Ventilation Hood has an oil leakage?
If your Smeg Ventilation Hood experiences oil leakage, it could be due to the one-way valve and air ventilation entrance not being tightly sealed. In this case, take down the one-way valve and seal it with glue. Another possible cause is leakage from the connection of the U-shaped section and cover, so take the U-shaped section down and seal it with soap or paint.
How to troubleshoot a Smeg SPUM90X when the light and motor don't work?
If the light and motor on your Smeg Ventilation Hood don't work, the light may be damaged, requiring replacement. Additionally, the power cord might be loose, so connect the wires as per the electric diagram.
Steps for preparing the installation, including drilling holes and measuring.
Instructions for mounting the hood using screws and fixing it to the cabinet.
Steps for attaching the mounting bracket and securing the hood to the wall and cabinet sides.
Procedure for fixing the hood to the cabinet from the top using screws, washers, and nuts.
Requirements and adherence for a valid warranty claim, including proper use and installation.
Specific situations and damages not covered by the manufacturer's warranty policy.
Warranty durations for different Smeg appliance categories like blenders and mixers.
General| Type | Wall-mounted |
|---|---|
| Width | 90 cm |
| Number of Speeds | 3 |
| Lighting | LED |
| Installation | Wall-mounted |
| Number of Lights | 2 |
| Material | Stainless steel |
| Energy Efficiency Class | A |
| Number of Motors | 1 |
| Filter Type | Aluminum grease filter |
To Next Page
