What to do if my Smeg ST2FABR2 Dishwasher has a water intake malfunction?
If your Smeg Dishwasher has a water intake malfunction, first check that the water connections are correct. Then, make sure the water intake tap is turned on and the filter is not fouled. If the problem persists after these checks, contact the after-sales service.
What to do if my Smeg ST2FABR2 has a water pump-out malfunction?
If your Smeg Dishwasher experiences a water pump-out malfunction, check that the drain hose is not kinked or crushed. Also, ensure that the siphon and filter are not fouled. If the issue continues, contact the after-sales service.
Why does my Smeg ST2FABR2 Dishwasher keep tripping the safety level?
The safety level in your Smeg Dishwasher might be tripping because the system that limits the water level inside the dishwasher has been activated. To resolve this, interrupt the program and switch off the dishwasher. Then, switch the dishwasher back on, program it again, and start the washing cycle. If the problem persists, contact the after-sales service.
What to do if my Smeg ST2FABR2 has a water heating malfunction?
If your Smeg Dishwasher has a water heating malfunction, repeat the washing program. If the problem continues, contact the after-sales service.
What to do if my Smeg ST2FABR2 Dishwasher has a water temperature monitoring malfunction?
Interrupt the program and switch off the Smeg Dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the after-sales service.
General| Type | Freestanding |
|---|---|
| Capacity | 13 place settings |
| Energy Efficiency Class | A++ |
| Noise Level | 43 dB |
| Number of Programs | 10 |
| Built-in Display | Yes |
| Tub Material | Stainless Steel |
| Outlet Hose Length | 150 cm |
| Delayed Start Timer | Yes |
| AquaStop Function | Yes |
| Connected Load | 1800 W |
| Power Consumption (off) | 0.5 W |
| Delay Start | Yes |
| Half Load Option | Yes |
| Width | 598 mm |
| Inlet Hose Length | 1.5 m |
| Washing Programs | Soak, Crystal, Super |
| Drying System | Natural condenser drying |
| Delayed Start | Up to 24 hours |
| Water Consumption | 9.5 L |
To Next Page
