What to do if my Smeg STE8639L shows error E6?
If your Smeg Dishwasher displays error code E6, first ensure that the drain hose isn't kinked or crushed. Also, check that the siphon and filter are not blocked. If the issue continues after these checks, contact after-sales service.
What to do if my Smeg STE8639L Dishwasher shows error E5?
If your Smeg Dishwasher displays error E5, verify that the water connections are correctly installed and that the water intake tap is fully open. Also, inspect the filter to ensure it is clean and free from blockages. If the problem continues, contact after-sales service.
What to do if my Smeg STE8639L Dishwasher displays error E2?
If your Smeg Dishwasher shows error code E2 or E4, interrupt the current program and switch the dishwasher off. Turn it back on, reprogram it, and restart the wash cycle. If the error persists, contact after-sales service.
What to do if my Smeg STE8639L Dishwasher displays error E4?
If your Smeg Dishwasher shows error code E4, interrupt the current program and switch the dishwasher off. Turn it back on, reprogram it, and restart the wash cycle. If the error persists, contact after-sales service.
What to do if my Smeg Dishwasher shows error E3?
If your Smeg Dishwasher displays error code E3, try repeating the wash program. If the problem remains after repeating the program, contact after-sales service for further assistance.
General| Number of place settings | 13 |
|---|---|
| Delay start | Yes |
| Half load | Yes |
| Colour | Stainless Steel |
| Type | Built-in |
| Size | 60 cm |
| Appliance placement | Fully built-in |
| Drying system | Natural condenser drying |
To Next Page
