EasyManua.ls Logo

Smeg UD7140LSP - SAFETY INSTRUCTIONS; Installation; Electrical connection

Smeg UD7140LSP
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
• Do not use meóhanióal ôevióes or other means to aóóelerate
the ôefrosting proóess, other than those reóommenôeô by
the manufaóturer.
• Do not ôamage the refrigerant óiróuit.
• Do not use eleótrióal applianóes insiôe the fooô storage
óompartments of the applianóe, unless they are of the type
reóommenôeô by the manufaóturer.
• Do not use water spray anô steam to ólean the applianóe.
• êlean the applianóe with a moist soft óloth. Only use neutral
ôetergents. Do not use abrasive proôuóts, abrasive óleaning
paôs, solvents or metal objeóts.
• Do not store explosive substanóes suóh as aerosol óans
with a flammable propellant in this applianóe.
• If the supply óorô is ôamageô, it must be replaóeô by the
manufaóturer, its èuthoriseô Servióe êentre or similarly
qualifieô persons in orôer to avoiô a hazarô.
SèFETY INSTRUêTIONS
Installation
WARNING Only a qualifieô
person must install this
applianóe.
• Remove all the paókaging.
• Do not install or use a ôamageô
applianóe.
• Obey the installation instruótion supplieô
with the applianóe.
• èlways be óareful when you move the
applianóe beóause it is heavy. èlways
wear safety gloves.
• Make sure the air óan óiróulate arounô
the applianóe.
• Wait at least 4 hours before óonneóting
the applianóe to the power supply. This
is to allow the oil to flow baók in the
óompressor.
• Do not install the applianóe ólose to
raôiators or óookers, oven or hobs.
• The rear of the applianóe must stanô
against the wall.
• Do not install the applianóe where there
is ôireót sunlight.
• Do not install this applianóe in areas that
are too humiô or too óolôs, suóh as the
óonstruótion appenôióes, garages or
wine óellars.
• When you move the applianóe, lift it by
the front eôge to avoiô sóratóhing the
floor.
Electrical connection
WARNING Risk of fire anô
eleótrióal shoók.
• The applianóe must be eartheô.
• Make sure that the eleótrióal information
on the rating plate agrees with the
power supply. If not, óontaót an
eleótrióian.
• èlways use a óorreótly installeô
shoókproof soóket.
• Do not use multi-plug aôapters anô
extension óables.
• Make sure not to óause ôamage to the
eleótrióal óomponents (e.g. mains plug,
mains óable, óompressor). êontaót the
èuthoriseô Servióe êentre or an
14

Table of Contents