How to fix ice formation inside my Smeg Freezer?
Ice formation inside the freezer can be addressed by: * Checking and cleaning the door gasket, or replacing it if it's damaged. * Avoiding frequent or prolonged door openings. * Ensuring that you are not inserting hot food into the freezer.
What to do if my Smeg Freezer doesn't turn on?
If the appliance does not operate after connection to the mains, check if there is power in the socket and if the appliance is switched on.
How to troubleshoot my Smeg UKM235XNF Freezer?
If you are not able to fix the trouble, turn the thermostat button to the off position, disconnect the power cord from the mains outlet, wait 10 minutes, and reconnect the appliance. Should this not help, please call for service assistance, quoting information given on the rating plate either within, or at rear of the appliance.
Why is the red light on my Smeg UKM235XNF Freezer?
The red light may be on due to several reasons: * Frequent opening of the door, or leaving the door open too long. * The door is not closed properly, possibly due to an obstruction in the door gasket, a sagged door, or a damaged gasket. * An excessively long power failure occurred. * An excessive amount of fresh food was inserted at once.
What to do if my Smeg UKM235XNF cooling system runs constantly?
If the cooling system operates continuously without stopping, consider the following: * Ensure adequate air circulation for compressor cooling and clean the condenser. * Check if the ambient temperature is too high. * Reduce frequent door openings and avoid leaving the door open for extended periods. * Make sure the door is properly closed, checking for obstructions or gasket issues. * Avoid inserting excessive quantities of fresh food at once. * Check if the ‘Intensive freezing’ option is activated.
What to do if my Smeg UKM235XNF door is hard to open?
If you find it difficult to open the door immediately after closing it, this is due to a vacuum created by the cooling of warm air that enters when the door is opened. Wait a few minutes to allow the pressure to normalize, and then you should be able to open the door easily.
How to replace the bulb in my Smeg UKM235XNF?
To replace the light bulb: 1. Disconnect the appliance from the power supply. 2. Remove the plastic cover. 3. Replace the bulb with a new one (E 14, max. same voltage as the factory one). 4. Fit the cover back in place. Dispose of the old bulb correctly. Note that the light bulb is a consumable item and is not covered by the warranty.
To Next Page
General
