10
WWW.SMITTYBILT.COM
Gen 1 Ladder Adjustment
Periodically check torque
of all hardware.
Gen 1 sliding ladder features several adjustment holes for ladder height
adjustment. You may drill additional holes if you need to fine tune or
shorten the length of the ladder. Do not drill any adjustment holes below
the bottom factory pre-drilled hole as damage will occur. Use a 3/8” drill
bit to drill new adjustment holes.
If ladder needs to be longer, Ladder extension #2785 is available
separately and will add 12” per extension.
Ladder extension part#2785
Bottom most pre-drilled hole
To Next Page
Loading...
