5
WWW.SMITTYBILT.COM
Overlander Tent
Mounting Extrusion - Attachment Instructions
Step 1: Remove mounting extrusion from the carton (cut as per slide 3 if you intend opening the
rooftop tent off the rear of your vehicle.)
Step 2: Place the tent on its side on the ground onto a clean surface.
Step 3: Using the supplied M6 bolts and washers, slide your hand in between the inside of the
base and the mattress and insert the bolts into the pre-drilled holes.
Step 4: Place the mounting extrusion into position over the bolts.
Step 5: Slide the 6mm nuts into the mounting extrusions and tighten the bolts from inside the
tent. Do not over tighten hardware. NOTE: as the tent base conforms and settles over time, you
will be required to re-tighten the mounting hardware.
Periodically check torque
of all hardware.
To Next Page
Loading...
