6
WWW.SMITTYBILT.COM
Overlander Tent
Ladder - Attachment Instructions
Step 1: Mount the ladder brackets to the base of the tent using M6x40mm bolts. Bolt each
ladder bracket to the base of the tent through the pre-drilled holes.
Step 2: Mount the Ladder brackets to the ladder using the supplied M6mm x 20mm bolts,
washers, plastic washers, and nut. Plastic washers will go on both sides of the bracket on the
ladder.
Note: Thread locker is highly recommended for these bolts as an extra measure for vibration
resistance. Do not over tighten bolts , ladder must be able to rotate on ladder mount. Check
movement, tighten hardware slightly, check movement and repeat till there is a slight resistance
when rotating the ladder.
Periodically check torque
of all hardware.
View from inside the tent
Ladder to ladder bracket
attachment
Plastic washers
To Next Page
Loading...
