WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
XRC 3.0 3,000lb Winch
Part # 97203
MAINTENANCE
1. Periodically check the tightness of the mounting bolts and electrical connections. Remove all dirt
or corrosion and always keep clean.
2. Do not attempt to disassemble the gear box. Repairs should be done by and authorized repair
center.
3. The gear box has been lubricated using a high temperature lithium grease and is sealed at the
factory. No internal lubrication is required.
REPLACING THE WIRE CABLE
1. If the wire cable has become worn or is beginning to show signs of strands breaking it must be
replaced before being used again. To do this, remove the defective cable be free spooling it out.
Remove the 5 x 5mm bolt on the drum and release the cable.
2. Insert the end of the new cable and secure with the previously removed bolt.
3. Engage the clutch and re-spool the new cable on the drum keeping tension on the cable as it
spools. Ensure that the cable is re-spooling in the under wind position.
NOTE: Only replace the cable with the identical manufacturer’s cable.
To Next Page
Loading...
Need help?
General
