What to do if my Smoke Guard Safety Equipment has no power?
If your Smoke Guard Safety Equipment has no power, the issue might be that no 120 VAC is supplied to the control. Check the wiring integrity to the junction box and inside the housing to resolve this.
Why does my Smoke Guard M200 make a clicking sound when power is supplied?
A clicking sound when power is supplied to your Smoke Guard Safety Equipment usually indicates a bad ground causing clutch chattering. To fix this, ensure you supply a proper earth ground to the housing.
What to do if Smoke Guard M200 system doesn’t respond to SRS?
If the Smoke Guard Safety Equipment system doesn’t respond to SRS, it could be due to attempting to use SRS too quickly after deployment or an SRS issue. Wait several seconds after deployment before pressing SRS again. Also, check the SRS wiring integrity.
What to do if Smoke Guard M200 has diode issue?
If your Smoke Guard Safety Equipment has a diode issue, it might be due to no EOL diode installed or the diode being installed incorrectly. Confirm proper EOL diode installation at the initiating device.
How to fix Smoke Guard M200 Safety Equipment door that won’t close?
If the door of your Smoke Guard Safety Equipment won’t close, the ceiling or soffit might be pinching the housing. Make sure there is greater than 1/8” gap between the housing and the ceiling or soffit.
General| Brand | Smoke Guard |
|---|---|
| Model | M200 |
| Category | Safety Equipment |
| Language | English |
To Next Page