!
5 Power up
!
1.!!
Insert the external power supply into your Juicerack/block (or IEC cable for Juicerack8).
2. Push the power button on your Juice power supply.
3. If you are using a microphone pre-amp and a condensor microphone, push the phantom
power button.
6 Juicerack 1
!
JuiceRack1 is a single-slot power source for operating one 500-series module. It is a half-rack
format, and includes a connector that allows two Juicerack 1’s to be mounted into a 1 ru 19” rack.
The external AC power supply design, keeps the power transformer separated from your 500
module’s sensitive electronics, and ensures reduced hum and signal interference.
7 Juicerack 3 & Juiceblock3
Juicerack 3 and Juiceblock3 are 3 slot power supplies for your 500 series modules. The rear panel
includes balanced XLR inputs and outputs along with balanced TRS 1/4” inputs and unbalanced
outputs. A 48V phantom power switch is located on the rear. These 3 slot models include front
panel buttons allowing audio routing between modules without the need for manual cable patching.
7.1 Audio Routing:
• FEED - Sends the audio output of one module into the next module
• LINK1 - Split a single balanced input and sends it to multiple modules simultaneously
• LINK2 - Split a single unbalanced input and sends it to multiple modules simultaneously
Onboard LEDs indicate which modules are using the FEED / LINK features, with each slot’s status
independently configurable.
!
!
!
!
!
!
!
!
!
To Next Page
Loading...