EasyManuals Logo

Snap-On 692024 User Manual

Snap-On 692024
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
TROUBLESHOOTING GUIDE
22
Problem Probable Cause Solution
AC outlet circuit breaker
trips
1. Circuit (outlet) over-
loaded.
2. Extension cord is too
long or wire size too
small.
3. Nozzle partially
blocked causing
excessive pressure.
.
1. Make sure circuit is
rated at 15 amps or
greater and unit is
plugged into a
dedicated circuit.
2. Use proper extension
cord (see instruc-
tions).
3. Clean Nozzle (see
instructions).
Motor stops suddenly
1. Extension cord is too
long or wire size too
small.
2. Thermal safety switch
has tripped due to
overheating and over-
work.
1. Remove extension
cord or use proper
extension cord (See
instructions).
2. Make sure main sup-
ply voltage corre-
sponds to specifica-
tions. Allow to cool
and restart unit.
Unit will not stop when
trigger is released
1. Gun/Hose Assembly is
defective.
1. Remove Wand from
the Gun and squeeze
trigger to ensure that
the water is coming
out of the front of the
Gun at a rate equal to
the Garden Hose. Call
Customer Service:
1-888-278-8092.
Unit begins to smoke
1. Overheated, over-
loaded or damaged
motor.
1. Turn off unit and Call
Customer Service:
1-888-278-8092.
Trigger will not move
1. Gun Safety Lock in
engaged.
1. Release Safety Lock
(See instructions).
TROUBLESHOOTING GUIDE
21
Problem Probable Cause Solution
Gun/Hose - Leaking water
1. Loose fitting. 1. Tighten fittings. If per-
sists, Gun/Hose will
need to be replaced.
Call Customer Service:
1-888-278-8092.
Pump is noisy
1. Pump is sucking air. 1. Make sure hoses and
fittings are air tight.
Turn off machine and
purge pump by
squeezing trigger gun
until a steady flow of
water emerges through
the nozzle.
No water coming out of
Wand
1. Clogged Nozzle.
2. Wand is attached
incorrectly.
3. Clogged filter.
4. Kink in the Garden
Hose or Hose is
wrapped on a storage
wheel.
5. Gun/Hose Assembly is
defective.
1. Clean Nozzle (See
instructions).
2. See instructions.
3. Clean filter (see
instructions)
4. Unwrap the Garden
Hose and lay it out flat
to ensure that there
are no kinks in the
Hose.
5. Remove Wand from
the Gun and squeeze
trigger to ensure that
the water is coming
out of the front of the
Gun at a rate equal to
the Garden Hose. Call
Customer Service:
1-888-278-8092.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Snap-On 692024 and is the answer not in the manual?

Snap-On 692024 Specifications

General IconGeneral
BrandSnap-On
Model692024
CategoryPressure Washer
LanguageEnglish

Related product manuals